[time-nuts] 10811 Extra Lagging etc
Brooke Clarke
brooke at pacific.net
Tue Jun 20 23:54:19 UTC 2006
HI Rick:
For humidity control in other applications I have used Zip-Lok bags.
How about putting the 10811 in a Zip-Lok bag and run the wires through a
hole that gets epoxy sealed? Some desiccant would lower the humidity if
that is an advantage.
Have Fun,
Brooke Clarke
--
w/Java http://www.PRC68.com
w/o Java http://www.pacificsites.com/~brooke/PRC68COM.shtml
http://www.precisionclock.com
Richard (Rick) Karlquist wrote:
>>Given that HP's engineers have done such a good job with
>>the oven and oscillator design, is there anything to be gained
>>by adding extra thermal insulation (lagging)? How much
>>
>>
>
>Not a good idea. The best thing you could do to improve
>temp stability of a 10811 is to tweak the resistors that
>proportion the power between the two heater transistors.
>At some ratio, the thermal gain will peak at over 1000
>typically. If you just take pot luck, you would be lucky
>to do 100. You are still limited by the tempco of the
>electronics, no matter what thermal gain you achieve at
>the crystal.
>
>You should also be aware that the 10811 is fairly humidity
>sensitive, which can seem like temperature sensitivity
>if the humidity and temperature change together.
>
>The HP E1938 was a much better design in terms of environmental
>insensitivity, but that didn't help much because the
>ultimate stability was limited by crystal frequency jumps,
>which didn't seem so bad with the 10811 due to the large
>environment errors in it. In the E1938 they stuck out like
>a sore thumb.
>
>Rick Karlquist N6RK
>
>
>_______________________________________________
>time-nuts mailing list
>time-nuts at febo.com
>https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>
>
>
More information about the Time-nuts_lists.febo.com
mailing list