[time-nuts] Time Interval measure mesurements
Brian Kirby
kirbybq at bellsouth.net
Tue Jun 27 00:39:52 UTC 2006
The 5262A is rated 1 microsecond to 1x10+8 seconds, so the maximum input
is rated at 1 Mhz.
John Ackermann N8UR wrote:
> Bruce Lanning wrote:
>
>> I am trying to compare my Freq, Std, HP-Z3801A GPS Receiver, to my home brew
>> Freq Std. using my Freq. counter, a HP-5245L with a Time Interval Unit
>> (HP-5262A) Plug in. Can someone help me. My counter Time Base opens about
>> 6-8 times and then gives me a reading like 1,345,000.1 My problem is the 6
>> to 8 times that the Time Base opens and then the reading like the one I get.
>> The manual on the counter and the Time Interval Unit give me no information.
>> Can one of you Time-Nuts out there tell me what is going on or is my Time
>> Interval Unit defective?
>> Bruce W1GBS
>>
>
> Bruce, can you give a little more detail about the measurement setup?
> In particular, are you measuring 1pps or 10MHz, and what mode is the
> counter set to? Which signal is hooked up to what input? Is there any
> indication on the display of what the units are?
>
> John
>
> _______________________________________________
> time-nuts mailing list
> time-nuts at febo.com
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>
>
More information about the Time-nuts_lists.febo.com
mailing list