[time-nuts] Oncore VP problem
GandalfG8 at aol.com
GandalfG8 at aol.com
Wed Jul 18 00:39:10 UTC 2007
In a message dated 17/07/2007 23:09:36 GMT Daylight Time,
randy at geodetics.com writes:
You should be able to restart the VP with the @@Cg command in the
"Additional Message Window" in WinOncore12. The total command string is:
@@Cg01<enter>.
Note that with the VP this must be done after every receiver default or
SelfTest.
----------
You will also encounter trouble trying to run a lot of the more esoteric 8
channel messages that the VP supported. WinOncore12 has no idea about what
to do with these. Once again, Rick's software will come to the rescue.
Best regards,
Randy Warner
Senior Applications Engineer
Geodetics, Inc.
---------------------------
Thanks Randy
That saved the day.
It was one of those things that seem silly when you know but a real pain
when nothing wants to work.
The unit did come with some earlier DOS software and a while ago I booted up
the Dolch luggable, that I keep for the Z3801A and SatStat, and ran the DOS
GPS90 software but that was doing the same thing.
My problem???
The VP comand set document doesn't mention, or not that I can see anyway,
the need for that leading zero, so I was using @@Cg1.....and it don't like
that:-)
Considering the antenna is only propped up on a ground floor window sill for
now, and signal levels are on the low side, all is looking good, with a 10
degree mask angle it's seeing 10 or 11 satellites and so far tracking 3.
It turns out to be an early 8 channel, a B3 model, but as long as it has the
1PPS output, that should be ok for what I need.
Thanks too for the other information, I'll look out for a copy of TAC32 and
try that later.
regards
and thanks again
Nigel
GM8PZR
More information about the Time-nuts_lists.febo.com
mailing list