[time-nuts] TAPR TADD-2 PIC frequency divider
Magnus Danielson
magnus at rubidium.dyndns.org
Sat May 23 13:16:21 UTC 2009
John Ackermann N8UR skrev:
> Magnus Danielson said the following on 05/23/2009 07:45 AM:
>
>>> Since the TADD enclosure has two DB-9 cutouts, one nice option (which
>>> I haven't tried yet) would be to wire the LED, the 5/10 MHz jumper,
>>> and the ARM switch connections to a DB-9 and mount that in the
>>> enclosure, then mount the LEDs and jumpers to a mating connector.
>>
>> I was actually contemplating the same. I think that would be a good
>> solution. It would also allow for remote control and monitoring.
>> Tossing in a PPS in there should not be hard and would make sense.
>
> There's a "secret" extra PPS output available that could be used on the
> DB-9. Look behind the ARM connector and you'll see a pair of pads
> labeled "AUX PPS". Those are a simple PPS signal buffered by a leftover
> gate on the 74AC14. Not a nice low Z output like the primary ones, but
> potentially useful...
It was the AUX PPS I had in mind.
Cheers,
Magnus
More information about the Time-nuts_lists.febo.com
mailing list