[time-nuts] ADEV vs MDEV
Magnus Danielson
magnus at rubidium.dyndns.org
Sun Feb 7 00:13:15 UTC 2010
Bruce Griffiths wrote:
> If one has a high end sound card then it could be used to implement the
> bandpass filter and replace the zero crossing detector.
> It may be necessary to insert a pilot tone to calibrate the sound card
> sampling clock frequency.
> A noise floor of about 1E-13/Tau should be achievable.
> This simplifies the DMTD system by replacing the zero crossing detector
> with a low gain linear preamp.
>
> If one analyses the resultant data off line then one can also try out
> different techniques such as a Costas receiver rather than a simple
> bandpass filter plus zero crossing detector.
> However 1000 seconds of data for 2 channels of 24 bit samples at 192KSPS
> will result in a file with a size of at least 1.15GB.
First step would be to implement a real-time first-line receiver
processing. Should not be too hard. Costas-loop isn't too complex to
implement, but for full repeatability using the same signals for
different set of parameters... but then again, it is fairly
straight-forward to implement.
Using either a separate channel or FDM a reference 1 kHz (from say
TADD-2 divider) should work for reference tone. A good board can be
word-clock locked without too much hazzle.
Not too happy about the quality of the real-time spectrum apps I have seen.
Cheers,
Magnus
More information about the Time-nuts_lists.febo.com
mailing list