[time-nuts] 10 MHz reference switching
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Mon Mar 8 23:43:40 UTC 2010
life speed wrote:
> Hello Time Nuts,
>
> I'm back again. I designed bandwidth-limited (30 MHz) ADA4899-1 opamp circuits to buffer the 10 MHz reference, with theoretical noise of less than 3 nV/rtHz. Oscillator noise is about -155 dBc/rtHz from 1 KHz to 10 KHz, and -160 dBc/rtHz from 10 KHz to 100 KHz. Unfortunately the rest of the design is holding up PCB manufacture, so results on these won't be available for awhile.
>
> Which brings me to the other design-stopping considerations: Is anybody aware of low-noise analog switches that can be used to reconfigure the 10 MHz reference paths without significantly degrading the phase noise? As always, I believe 1/F noise would be the concern. Non-reflective is great, but I can accomplish that by using more switches and 50 ohm resistors if need be. Isolation is a key consideration as well. Mechanical relays are out of the question.
>
> An alternative to switching is phase-locking the OCXO to an external reference. I have thoroughly looked into this possibility, and it is likely my preferred approach. But I need to understand how the switching approach compares, hence my question. I do not need help with phase-locking; this feature is readily available from OCXO vendors who have dedicated years of research to optimizing their products.
>
> Any switch experience out there?
>
>
Why would flicker noise be a concern if there is no dc current flowing
in the switches?
Bruce
More information about the Time-nuts_lists.febo.com
mailing list