[time-nuts] is my Oncore UT+ dead or live?
ernieperes at aol.com
ernieperes at aol.com
Sat Jan 8 10:58:40 UTC 2011
Hi Chris,
use the TAC32 software to initialize the gps board.... probably when you power up it comes into binary mode,
not NMEA mode....
Rgds Ernie.
-----Original Message-----
From: Chris Albertson <albertson.chris at gmail.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Sat, Jan 8, 2011 10:41 am
Subject: [time-nuts] is my Oncore UT+ dead or live?
How does one tell a dead Oncore UT+ from a live one? Sounds like a
illy question but the user manual says they produce no output until
ou send it some commands.
I connect an older Germin GPS to the same cable and a flood of NMEA
essages appears in a terminal window. I'm running Linus and just
sing "cat" to send ad receive data.
--
====
hris Albertson
edondo Beach, California
_______________________________________________
ime-nuts mailing list -- time-nuts at febo.com
o unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
nd follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list