[time-nuts] Pulse width for start signal for HP5370
Paul A. Cianciolo
paulc at snet.net
Sat Sep 3 18:14:45 UTC 2011
Hello,
Following a suggestion given to me I am using a 1PPS signal to "START" the
HP5370.
The "STOP" is the normal the DUT 10 Mhz.
The pulse comes from a Z3801 rear Db 25 connector.
The counter seems to work ok with this except the level control does not
have a lot of range.
Too far CW and the level light stays on, to far CCW and the level light
goes.
There is some range but not a lot.
Does seem normal to you folks?
Paul A. Cianciolo
W1VLF
http://www.rescueelectronics.com/
"Time is relative" Abert Einstien circa 1950
"Relatives use up all my time" Lisa Cianciolo circa 1983
More information about the Time-nuts_lists.febo.com
mailing list