[time-nuts] FE5680A square-wave output
bob grant
bobgrant at fastmail.fm
Mon Feb 13 23:08:52 UTC 2012
I'm not that fond of the way in which 10MHz is made available on a DB9.
But there's a vacant site for an AC161 on the FE5680 PCB to perform a /6
operation from the 60MHz crystal. To good an opportunity to miss up....
Here is some pics of the mod.
http://s1090.photobucket.com/albums/i370/bobgrant1/TimeNutz/?albumview=slideshow
There is scant decoupling here, and it shows up as 6 blips in
high/low signal levels whenever there is a signal transition.
I needed to add a tantalum, X7R, C0G and a small piece of FR4 with Cu
tape.
The output is on a RG178 SMA pigtail.
Series termination worked best with 47R and 330R in parallel delivering
a reasonably nice 5V signal.
Earlier you may recall the "Why a 10MHz sinewave?" thread, and for those
there are component sites for 390p and 1uH which make a wide bandpass
filter.
Have fun
--
http://www.fastmail.fm - A no graphics, no pop-ups email service
More information about the Time-nuts_lists.febo.com
mailing list