[time-nuts] getting a grip on 10811 drift (trying to read my instruments)
Neville Michie
namichie at gmail.com
Sat Nov 17 06:02:42 UTC 2012
I have found a pic of the dry joint,
this one was just a dry joint with resin insulating the connection,
the other never had any solder applied.
cheers, Neville Michie
On 17/11/2012, at 11:09 AM, Chris Howard wrote:
>
> Maybe that is my problem. I definitely have a problem.
>
> I am able to get the EFC to work on some occasions.
> Usually it will work if I run the trimmer all the way
> out and toggle the power. I can then adjust the trimmer
> and get things working. But if I give the box a rap
> the frequency jumps and I get into the "mode" of
> the EFC not working. I can trimmer it up and it will
> look fine but no EFC.
>
> I will check out that ferule thing. I'm not sure what you
> are describing but will look for it.
>
> Chris
>
>
>
> On 11/16/2012 5:53 PM, Neville Michie wrote:
>> I have had two 10811 with EFC problems that turned out to be lack of soldering of one internal joint.
>> This is a large PTFE ferule with several leads including the varactor and trimmer going into it. For many
>> years the leads all contacted but finally one lead developed an oxide film. A soldering iron fixed them very quickly.
>> The serial numbers were widely separated, so it was not an unlucky batch problem.
>> cheers,
>> Neville Michie
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list