[time-nuts] Z3801A trouble
Max Robinson
max at maxsmusicplace.com
Mon Jan 14 04:48:20 UTC 2013
Sounds like a left over Y2K problem.
Regards.
Max. K 4 O DS.
Email: max at maxsmusicplace.com
Transistor site http://www.funwithtransistors.net
Vacuum tube site: http://www.funwithtubes.net
Woodworking site
http://www.angelfire.com/electronic/funwithtubes/Woodworking/wwindex.html
Music site: http://www.maxsmusicplace.com
To subscribe to the fun with transistors group send an email to.
funwithtransistors-subscribe at yahoogroups.com
To subscribe to the fun with tubes group send an email to,
funwithtubes-subscribe at yahoogroups.com
To subscribe to the fun with wood group send a blank email to
funwithwood-subscribe at yahoogroups.com
----- Original Message -----
From: "Joseph Gray" <jgray at zianet.com>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Sunday, January 13, 2013 10:28 PM
Subject: Re: [time-nuts] Z3801A trouble
> Forcing the date on power up worked, although a bit strangely. I
> entered "2013,01,14" and got an "out of range" error. The date then
> showed as "14 Jan 2007" briefly, before showing "14 Jan 2013".
>
> Joe Gray
> W5JG
>
> On Sun, Jan 13, 2013 at 9:17 PM, Joseph Gray <jgray at zianet.com> wrote:
>> I just tried manually putting the unit into holdover and setting the
>> date. Same error. I'll have to try power cycling.
>>
>> Joe Gray
>> W5JG
>>
>> On Sun, Jan 13, 2013 at 8:57 PM, Hal Murray <hmurray at megapathdsl.net>
>> wrote:
>>>
>>> jgray at zianet.com said:
>>>> I did that command earlier, but got an error. I just tried it again and
>>>> I
>>>> get the same error:
>>>
>>>> -221 "Settings conflict"
>>>
>>> I don't remember any troubles. I wasn't using anything complicated like
>>> SatStat.
>>>
>>> You might have to set the time when it doesn't know it. Try power
>>> cycling
>>> and set the time before it finds the satellites and time.
>>>
>>>
>>> --
>>> These are my opinions. I hate spam.
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to
>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list