[time-nuts] Lady Heather and the NTGS50AA
Stanley
timenuts at n4iqt.com
Sat Jan 18 16:07:58 UTC 2014
Ignacio,
The "Strangely it worked a couple of times" maybe it has auto baud routine
that is active shortly after reset or power on.
Stanley
----- Original Message -----
From: "EB4APL" <eb4apl at cembreros.jazztel.es>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Saturday, January 18, 2014 8:27 AM
Subject: [time-nuts] Lady Heather and the NTGS50AA
>I have a NTGS50AA working with the Lady Heather last version which
>incorporate support for this board (Thanks Mask Sims).
> When I bought the board I used the Trimble utility GPS Monitor (GPSTM
> Commissioning Tool V1.5) to set it up and in the way knowing that it was
> previously working in Guatemala. This program uses COM1 or 2 with a
> fixed configuration of 19200, 7,Odd and 1stop bit. After using LH it seems
> that it changed the parameters to 9600.0.N,1 probably using an
> undocumented command and the board stores this configuration even if
> unpowered. But now I can't use the Trimble program because it refuses to
> connect, even it crashes when trying to connect at 19200 baud. Strangely
> it worked a couple of times when I was trying to command the leds in the
> panel but I don't know how it managed to change the baud rate.
> Does anybody know how to change the configuration of the board serial
> port, maybe an undocumented command? I have the manual but I don't find
> anything neither in the LH documentation.
>
> Regards,
> Ignacio
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list