[time-nuts] Z3816A Control and Cleaning
J. L. Trantham
jltran at att.net
Sat Jan 25 04:33:35 UTC 2014
All,
I had already set the local time zone offset from GPS to '0' so I can't
address the success or not of the following commands if the 'offset' has not
been set to '0'.
:DIAG:GPS:UTC 1
Worked great to set the system from GPS time to UTC time. However, nothing
changed on the display until I hit:
*tst?
That set the ALARM for a few seconds then the receiver 'reset'. It had to
re-acquire satellites which took a while but it came up with GPS LOCK and
displaying UTC time.
If you send:
:DIAG:GPS:UTC?
It will return '1' for UTC or '0' for GPS, depending on what the Z3816A is
set for.
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Donald Henderickx
Sent: Friday, January 24, 2014 9:57 AM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Z3816A Control and Cleaning
On 1/23/2014 11:30 PM, Hal Murray wrote:
>> Also, I seem to recall a command that can be sent by SatStat to
>> change from GPS time to UTC time but I can't find it in my files. Is
>> there such a command or am I hallucinating?
> My notes for the Z3801A say:
> :diag:gps:utc 1
> http://www.realhamradio.com/GPS_User_Notes.htm (undocumented)
>
>
My Z3801 notes which came from Bill Jones K8CU show the same however in
upper case.
I added a note that it did not work until local time zone was set to
0hrs 0min.
Don H
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list