[time-nuts] KS-24361 EFC Error
GandalfG8 at aol.com
GandalfG8 at aol.com
Tue Aug 11 20:35:11 UTC 2015
Bevor I heat up the big soldering iron to remove the OCXO, I wanted to
ask if anybody else experienced this before and if anybody can confirm
that tuning voltage range is indeed 0..6 Volt. If so, replacing the OCXO
should cure the problem.
Hi Mathias
I've not experience your problem with the KS-24361, but I have tested a
few of these oscillators stand alone and can confirm that the reference
voltage output has always been approximately 6 Volts and they do accept an EFC
tuning voltage range of 6 Volts.
Other than one faulty unit, on all those I've tested the EFC voltage has
been very close to 3 Volts when the oscillator frequency was within a few
parts in 10^11 of 5 MHz.
For example, looking back at a couple of test results, one was at 2.9725
Volts and another at 3.0970 Volts.
Regards
Nigel
GM8PZR
Hey, hows about that, It seems like I might finally have found a way to
reply to list messages straight from the archives without receiving them by
email:-)
More information about the Time-nuts_lists.febo.com
mailing list