[time-nuts] LPRO-101 BITE (~lock) Signal Always Low
Wayne (gmail)
wayne.holder at gmail.com
Tue Mar 22 12:43:53 UTC 2016
The BITE signal is the only way to to know if it has a lock...
Wayne
> On Mar 22, 2016, at 4:37 AM, Bob Camp <kb8tq at n1k.org> wrote:
>
> Hi
>
> There are probably a dozen or more things that contribute to the BITE output. It could be
> a regulator out of range. It also could be the VCXO nearing tune limit. If the unit locks up and
> seems to work, I’d ignore it and move on.
>
> Bob
>
>> On Mar 21, 2016, at 9:42 PM, Wayne Holder <wayne.holder at gmail.com> wrote:
>>
>> I have a surplus LPRO-101 that seems to power up OK. The power draw starts
>> at 1.7 Amps and then, after a few minutes, drops down to 600 mA, or so and,
>> after this startup, the output shows a 10.000 MHz signal thats 's
>> accurately as I can measure it. The lamp voltage is 6.2 volts, which seems
>> within spec. However, the BITE signal that's supposed to indicate lock
>> with a LOW level is always LOW and never changes. The docs say that BITE
>> signal should start at a HIGH level to indicate no lock and then drop to a
>> LOW when lock is obtained. So, this behavior seems all wrong.
>>
>> I opened the case and observed the purple glow of the lamp and probed
>> around IC U401, which buffers the BITE signal, and saw the same signal LOW
>> level. U401 is getting 5 volt power and the inputs to the AND gate used as
>> a buffer for the BITE signal match what I'd expect. But, lacking a proper
>> schematic, I'm not sure how to trace this back to the problem. Has anyone
>> ever seen a symptom like this with an LPRO101?
>>
>> Wayne
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list