[time-nuts] Spectrum Analyzer Specifications
Brooke Clarke
brooke at pacific.net
Wed Mar 23 23:43:10 UTC 2016
Hi Mike:
A lot depends on what you are going to be doing.
For example a few decades ago I built an automated system to measure mixer spurs where the frequency of the spurs was
known because I had control of the LO and RF frequency.
IF = +/-LO*n +/-RF*m
The first attempt used the HP 8350B sweeper for the LO and RF sources, but the phase noise was huge so that when you
looked at the IF on the spectrum analyzer the amplitude was jumping up and down many dB. Switched to synthesized signal
generators and that problem went away. Note that the instrument with the best LO was the source for the external
reference inputs for the other two instruments so that they all agreed on the frequency.
http://www.prc68.com/I/RASS_PP.html#Spur
PS A trick to save time is to set the start and stop frequencies so that the IF is just past the start frequency rather
than being centered. That way you can stop the sweep a little after the IF frequency cutting the sweep time by more
than a factor of 10.
PPS First generation spectrum analyzers use analog processing and so the resolution bandwidth is directly tied to the
sweep speed. A digital IF overcomes this limitation (is much faster) and also allows measuring noise power (I^2 + Q^2)
where the analog SA used peak detection. Also a digital IF allows for 1 Hz real RBW which in turns makes for fantastic
sensitivity. You can wrap a wire around a radio and see it's LO frequency. The HP/Agilent 4395A is such a digital IF SA.
http://www.prc68.com/I/4395A.shtml
Example of measuring LO frequency with the 4395A and a good 10 MHz external reference.
http://www.prc68.com/I/BlkBox.shtml
--
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.end2partygovernment.com/2012Issues.html
The lesser of evils is still evil.
-------- Original Message --------
> Hi,
>
> I have another question about test equipment. When using a spectrum analyzer
> to examine the output of a frequency standard, what are the minimum
> specification needed? Bandwidth, resolution, sensitivity, etc?
>
> Looking at spectrum analyzers on eBay, I see quite a bit of difference between
> various models. Some have a resolution of 10Hz but others are 30Hz or even
> 100Hz. Some have a minimum frequency of 0.01Hz, 100Hz or even in the kHz
> range. Some are only sensitive to 60dBm, but others over 100dBm.
>
> Are any of the cheaper USB spectrum analyzers worth getting?
>
> Most of these are appallingly expensive, so knowing what is needed can
> certainly help guide a purchase or to minimize cost. And if a "deal" is found,
> knowing that it is or is not adequate can help.
>
> Clearly, better specifications are preferable, but I'm also sure that the
> intended application makes a large difference. What is needed for examining a
> 10Mhz frequency standard might be remarkably different from what is needed for
> high-frequency RF work.
>
>
> Mike
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list