[time-nuts] Opening an Isotemp OCXO
Tom Miller
tmiller11147 at verizon.net
Fri Oct 28 16:41:02 UTC 2016
When I have an unknown OCXO, I put a scope on the output and connect a bench
power supply to the DC inputs. I bring up the voltage until the RF out hits
a stable level. That is where the internal regulator starts regulating. Then
set it to the nearest normal power supply voltage, +5, +12, +15, +24, +28
volts.
Some OCXOs will have separate inputs for the oscillator and the oven.
Example- an HP OCXO has a +15 regulated input that is switched for the
oscillator and a +24 volt input for the oven that is on always. I usually
try the same voltage as the oscillator first and watch the current as the
oven warms up. If it takes too long to heat up, try a little higher voltage.
Some units have a separate ground return for the oscillator and oven so you
need to watch that.
Good luck and thanks for the report.
Regards,
Tom
----- Original Message -----
From: "Peter Reilley" <preilley_454 at comcast.net>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Friday, October 28, 2016 12:09 PM
Subject: Re: [time-nuts] Opening an Isotemp OCXO
> The only document that I could find said 12 volt.
>
> Pete.
>
>
> On 10/28/2016 11:49 AM, Poul-Henning Kamp wrote:
>> --------
>> In message <10a3ea7d-37f0-51bc-2470-35645d767bbd at comcast.net>, Peter
>> Reilley writes:
>>
>>> The chip is run off 12 volts so it must be CMOS.
>> Or the OCXO is not a 12V model ?
>>
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list