[time-nuts] Thermal effects on cables --> ADEV
Bob Camp
kb8tq at n1k.org
Fri Jan 13 19:41:37 UTC 2017
Hi
That’s the way I read what they are saying. More or less: Keep the number of samples above
100, but below 300.
Bob
> On Jan 13, 2017, at 12:30 PM, Ole Petter Rønningen <opronningen at gmail.com> wrote:
>
> That IS interesting.. It reads to me that the advice is to keep a "moving 300 pt ADEV" when continously monitoring a (pair of) frequency source in e.g a VLBI site - the reason for limiting it to 300 pts being that much more than that is likely to average out potential issues..
>
> Does that make sense?
>
>> Den 13. jan. 2017 kl. 17.04 skrev Bob Camp <kb8tq at n1k.org>:
>>
>> Hi
>>
>> There’s an interesting comment buried down in that paper about limiting ADEV to
>> < 300 samples per point. Their objective is apparently to better highlight “systematic
>> errors”. I certainly agree that big datasets will swamp this sort of thing. I’m not quite
>> sure that I’d recommend ADEV to find these things in the first place. My guess is that
>> it’s the only spec they have to call the device good or bad in this case …They don’t seem
>> to have Hadamard in their list of variances. If I was going after systematics with a deviation,
>> that’s the one I’d use. Of course I probably would not use a something-dev in the first place.
>>
>> Bob
>>
>>
>>> On Jan 13, 2017, at 1:52 AM, Ole Petter Ronningen <opronningen at gmail.com> wrote:
>>>
>>> Hi, all
>>>
>>> The question of phase shifts in cables pops up every now and then on this
>>> list - I stumbled across a good table of measured phase shifts with
>>> temperature in different cable types in this paper:
>>> http://www.ira.inaf.it/eratec/gothenburg/presentations/ERATEC_2014_PresentationWSchaefer.pdf
>>> that I though would be of interest to others.
>>>
>>> A quick summary given below, see pdf for full details. Lots of other
>>> interesting stuff in there also.
>>>
>>> Values in ppm/K, for 10 Mhz except when otherwise stated. (The paper gives
>>> values for 5, 10 and 100Mhz)
>>>
>>> Huber-Suhner Multiflex 141: -6
>>> RG-223: -131.9
>>> Semiflex Cable: -11.5
>>> Huber-Suhner: -8.6
>>> Times Microwave LMR-240: -3.4
>>> Times Microwave SFT-205: 7.7
>>> Meggitt 2T693 SiO2: 30.6
>>> Andrew FSJ-1 (@5Mhz): 25
>>> Andrew FSJ-4 (@5Mhz): 10
>>> Andrew LDF-1P-50-42: 2.8
>>> Andrew LDF4-50A: 4.7
>>> Times Microwave TF4FLEX (@100Mhz):6.4
>>> Phasetrack PT210 (@100Mhz): 2
>>>
>>> Ole
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list