[time-nuts] Machining some aluminum help!
ed breya
eb at telight.com
Thu May 25 21:08:02 UTC 2017
This is the first time I've looked at time-nuts in about a month, and I
noticed the run about this project. I'm very late to the party, but have
a few suggestions that may help - if it's not too late. I quickly
scanned many of the posts, and agree with many of the ideas. Please
forgive if my suggestions are redundant to what's already been said.
First, I assume that the aluminum box is a simple extrusion, so it will
likely be a soft alloy that will tend to gall horribly with machining -
especially bad for anything that needs high precision. With these kinds
of material, go big, starting with bigger fasteners. With 1/4" walls,
you can easily up it to 6-32 or 8-32, as long as the holes are fairly
shallow, and you can jig it up for good centering and plumbness. With
4-40 and blind holes, you're just asking for trouble - especially taking
a chance 40 times. The tap drill will be quite skinny, and prone to
deform and wander as it goes in, and can easily be snapped off when it
stalls due to the galling - and that's just the drilling stage - the
tapping will be worse.
Bigger threads give you a chance to get it done with fewer fasteners and
holes, and much less grief. The thread depth should allow for at least
one pitch-diameter of penetration for strength, but preferably two or
more, so you don't have to worry about finding exact right screw lengths
that won't bottom out. Depending on the thickness of the end plates, you
could get down to two or three fasteners per side to hold the small
pressure needed.
If you're using a drill press, punch mark the hole centers, then use a
center drill to make the pilot holes for the tap drill. If you're
freehand drilling, put the piece on the floor and drill downward,
keeping it as plumb as possible. Definitely use an oil or other
lubricant for all the drilling and tapping operations.
For sealing, I'd recommend against fancy o-ring features and such -
these are also harder to machine cleanly in soft aluminum, and add
unnecessary complexity. If the end caps need regular remove and replace
operations, then go with a pliable gasket, have more fasteners to get
more uniform compression, and make the threads deeper so they'll last
longer. If the sealing is one-time, or seldom needs to be broken, I'd
recommend using a gasket sealing goop that will work fine with few
fasteners and even rough surface finish. My favorite is Permatex #2
"Form-A-Gasket Sealant," which I've used for all sorts of stuff over
fifty years (back then it was Radiator Specialties brand). Don't use a
silicone goop unless you want to spend a lot of time scraping off the
old stuff if it needs to be opened. If you do use a goop, it's a good
idea to machine in features for prying the lids off, such as
gasket-plane screwdriver slots, or extra tapped through-holes in line
with the mounting holes on of the lid.
Ed
More information about the Time-nuts_lists.febo.com
mailing list