[time-nuts] Lucent RFTG-u REF0-REF1 cable
Thomas Petig
thomas at petig.eu
Tue Nov 14 16:50:15 UTC 2017
Hi Jerry,
the 15 MHz is disabled by default, just bridging some pins enables the
output:
http://syncchannel.blogspot.se/2015/11/denuo-gps-hits-rev-b-dongles.html
If you want to insert some 1PPS signal to discipline it, you need some
fake some GPS messages. Dan has done some nice work here, a small ATTiny
is sufficient.
/Thomas, SA6CID
On Tue, Nov 14, 2017 at 08:30:54AM -0800, Jerry Hancock wrote:
> Bob, I thought you had to send it code, etc? I have the two units
> with cable, etc running upstairs. I want another one for in my office
> but the same guy only sells the REF0 and REF1 units separately now
> without the cable. I thought about splitting the two and using this
> other GPS unit I have (it was one of the TAPR GPS Kits) to send the
> other one the 1pps. You’re saying all you need is a plug? I would
> need two functioning units.
>
> Regards,
>
> Jerry
>
>
> Jerry Hancock
> jerry at hanler.com
> (415) 215-3779
>
> > On Nov 14, 2017, at 8:13 AM, Bob Camp <kb8tq at n1k.org> wrote:
> >
> > Hi
> >
> > If you are going to get out the soldering iron, why simply make up a plug
> > to run the GPS unit stand alone? Keep the second unit powered down
> > as a set of spare parts….. Yes, it does depend a bit on what you are doing
> > with them ….
> >
> > Bob
> >
> >> On Nov 13, 2017, at 11:50 PM, Jerry Hancock <jerry at hanler.com> wrote:
> >>
> >> Anyone have a spare cable for the Lucent setup? I guess I can make one with some DB15 connectors but trying to skip the effort.
> >>
> >> Thanks
> >>
> >> Jerry
> >> _______________________________________________
> >> time-nuts mailing list -- time-nuts at febo.com
> >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> >> and follow the instructions there.
> >
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list