[time-nuts] GN-GGB0710 GPS Antenna Mounting Thread
Mike Cook
michael.cook at sfr.fr
Thu Feb 14 20:45:17 UTC 2019
The doc from a Chinese site says
(Mounting Method)
5/8-11 Threaded installation
> Le 14 févr. 2019 à 21:09, Skip Withrow <skip.withrow at gmail.com> a écrit :
>
> Hello Time-Nuts,
> As I have been playing with some dual-band GPS receivers, I decided to
> order a dual-band antenna to replace my permanent L1 antenna that I
> use for all the GPSDOs. I purchased one of the Chinese TOPGNSS model
> GN-GGB0710 units. Much smaller than the choke ring I currently have
> up (which uses a 1"-10TPI thread).
>
> However, when I went down to the local hardware emporium to acquire
> parts to assemble a mounting bracket I seem to have run into an issue.
> A 5/8"-11 bolt appeared to be about right for the mounting threads,
> but bound after a turn or two. So, I went over to the metric section
> and found an M16-2 bolt. It started easily enough, but again bound
> after a couple of turns.
>
> Back home I measured the thread pitch and got .08175 inches. Turns
> out this is between the 5/8-11 thread (.0909") and the M16-2 thread
> (.0787").
>
> I looked up the Trimble antenna mounting specs and they specify 5/8-11
> for their geodetic survey antennas.
>
> Since the 5/8 hardware is a lot cheaper than the M16 I'll probably
> just use a 5/8 bolt and just screw it on reasonably tight and call it
> a day. Just wanted to give the list a heads-up. If there is a secret
> mounting thread out there please let me know.
>
> Thanks,
> Skip Withrow
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
I am not a a vegetarian because I love animals. I’m a vegetarian because I hate plants.
More information about the Time-nuts_lists.febo.com
mailing list