[time-nuts] Ublox Neo M8T no output on TP2 question please?

[Chris Wilson]

  17/01/2019 14:42

I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on
TP2. If I programme it with the UCentre software for say 500hZ output
I sill see nothing on TP2. Do I need to pull it high on boot or
anything to see an output please? I am not probing it with a X10 scope
probe until after it has booted, so I don't believe it's pulled low on
boot, although I can't see how a X10 probe setting could pull it
anyay. TP0 behaves normally and accepts changes in output frequency.
Otherwise it also seems to generally act correctly. Thanks

-- 
       Best Regards,
                   Chris Wilson.
mailto: chris at chriswilson.tv