[time-nuts] Ublox Neo M8T no output on TP2 question please?

[Chris Wilson]

Hello David,

Thanks  for  the  reply,  it  came froma recommended Lithuanian source,
where  others  have no issues with similar devices. I e-mailed them re
this  but  got no rely, sadly. Is there any way to interrogate it (not
the suppliers.... ;)) to see if it's legit?

 Thursday, January 17, 2019

 


Best regards,
 Chris        mailto:chris at chriswilson.tv


DJTvtn>   17/01/2019 14:42

DJTvtn> I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on
DJTvtn> TP2. If I programme it with the UCentre software for say 500hZ output
DJTvtn> I sill see nothing on TP2. Do I need to pull it high on boot or
DJTvtn> anything to see an output please? I am not probing it with a X10 scope
DJTvtn> probe until after it has booted, so I don't believe it's pulled low on
DJTvtn> boot, although I can't see how a X10 probe setting could pull it
DJTvtn> anyay. TP0 behaves normally and accepts changes in output frequency.
DJTvtn> Otherwise it also seems to generally act correctly. Thanks

DJTvtn>        Best Regards,
DJTvtn>                    Chris Wilson.
DJTvtn> =====================================

DJTvtn> Are you sure it's genuine ublox?  There are many counterfeits about.

DJTvtn> Cheers,
DJTvtn> David