[time-nuts] Z3801A going into Holdover
Bob kb8tq
kb8tq at n1k.org
Thu Jun 20 18:47:53 UTC 2019
Hi
Anything odd going on with the EFC voltage before / after holdover?
Bob
> On Jun 20, 2019, at 1:05 PM, Dan Rae via time-nuts <time-nuts at lists.febo.com> wrote:
>
> I have an elderly 3801A with some 182,000 hours on the clock, which if my arithmetic is correct means over twenty years of operation. Since it has a well aged and remarkably stable OCXO I would like to keep it going if possible. Recently it has been going into Holdover and staying there for no reason that I can see, it is fed from the same antenna / splitter amp combination with a good sky view as eight other GPSDOs here. LH reports as good a signal strength on it as any of the others. A Cold Reset gets it going again.
>
> Does anyone know if a more modern receiver can be fitted in place of the existing VP6? Is it likely to be a Rx problem anyway?
>
> I'm running LH at the moment and will try to capture a screen when it next goes into Holdover to see if that gives me any clues.
>
> Thanks for any advice!
>
> Dan
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list