[time-nuts] DC distribution
Paul Bicknell
paul at bicknells.f2s.com
Fri Oct 4 22:21:33 UTC 2019
Hi where the wire is too thin for the crimp
I actually strip the wire to long and fold it half
One reason to crimp is so there is not a hard line for a fracture
IE a point for the cable to brake
By soldering the joint you actually introduce a potential fracture point
It's all my time playing with aircraft and destructive testing
Sorry it was suppose to be non destructive testing but things brake at times
Paul
-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces at lists.febo.com] On Behalf Of John
Ackermann N8UR
Sent: 04 October 2019 22:08
To: time-nuts at lists.febo.com
Subject: Re: [time-nuts] DC distribution
The idea of using a short piece of thicker wire is a good one. Thanks
for that!
On 10/4/19 3:17 PM, MLewis wrote:
> With audio signals, a soldered crimp is one of the worst possible
> connections. I wouldn't think it would be different for anything else,
> but may go undetected until failure. If you've used the correct size of
> crimp and used a proper crimping tool, then you've got the proper
> pressure for a solid reliable connection. If you then solder, the heat
> expands the crimp lessening the crimp pressure, and when it cools it's
> no longer at the correct crimp pressure (often the wire will pull right
> out), and with iffy wicking of solder. The worst of both methods
> combined in one.
>
> Where the wire is too thin for the crimp I have available, I've cut a
> piece of a correct thickness wire/cable, inserted that into the crimp
> along with the signal wire/cable, so it's crimped between them. I don't
> know if that is the best way of handling that, but it's worked for me.
>
> On 04/10/2019 11:41 AM, John Ackermann. N8UR wrote:
>> West Mountain is a good source for all things PowerPole, but there are
>> a bunch of other vendors as well. And do youself a favor -- spend $30
>> on the three size 15/30/45 amp crimping tool. It saves much
>> aggravation. But if you're using thin wire, soldering after crimping
>> is a good precaution.
>>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to
> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts at lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.8048 / Virus Database: 4793/15886 - Release Date: 08/14/18
Internal Virus Database is out of date.
More information about the Time-nuts_lists.febo.com
mailing list