[time-nuts] GPS Antennas
Attila Kinali
attila at kinali.ch
Tue Oct 15 17:16:24 UTC 2019
On Tue, 15 Oct 2019 11:29:08 -0500
Bob kb8tq <kb8tq at n1k.org> wrote:
> There are a lot of 3D printers out there that happily print ABS ….
I am not sure that's a good idea.
The way how filament printers work will lead to lots of
pores where humidity can accumulate. Not something you want.
Thermoforming sheets, on the other hand, gives a smooth, closed
surface. Additionaly, the tensile strength of the sheet after
thermoforming is higher than that of filament printed structures.
This means a radome can be thiner, which leads to less lensing,
which is the major source of phase center shift.
Attila Kinali
--
It is upon moral qualities that a society is ultimately founded. All
the prosperity and technological sophistication in the world is of no
use without that foundation.
-- Miss Matheson, The Diamond Age, Neal Stephenson
More information about the Time-nuts_lists.febo.com
mailing list