[time-nuts] FA-2 Data Logger details
Perry Sandeen
sandeenpa at yahoo.com
Sat Oct 26 00:07:56 UTC 2019
Yo Bubba Dudes!
Thanks to E W Kehren, he sent me the data logger details from Jureg.
They are attached below. If it gets screwed up by yahoo mail, I'll make a PDF.
SDData Logger for FA-2
https://www.sparkfun.com/products/13712
SDLogger - Open Hardware Data Logger - Seeed Wiki
Ebay: Search OpenLog
Connection:
Gnd free plug behind the LCD → OpenLog Blk
+5V free plug behind the LCD →Switch → OpenLog VCC
Data FA-2 U13 R59 → OpenLog RX (thin wirewrap wire through unusedhole
from bottom of boardupwards)
Montage:
Rectangularcut-out at the FA-2 back side 4mm x16mm, 3.2 mm hole over cut-out (the exact position depends on the hexagon bolt)
6mm hole for the switch
Thereare no mounting holes on the OpenLog board. I glued a hexagonal bolt (M3 10mmlong) with Araldit (2 componentadhesive) onto the processor.
MicroSD Card
Config.txt
Write 9600,26,3,0 into a txt file with an editor.
Savethis as Config.txt on the SD card.
Inthis log mode a new log file is created on every startup (LOGXXXXX.txt).
Forother operating modes see the descriptions at Sparkfun or Seeedstudio.
Regards,
Perrier
More information about the Time-nuts_lists.febo.com
mailing list