[time-nuts] Low frequency noise measurement (was BG7TBL FA1 frequency analyzer )

[Peter Vince]

On Thu, 5 Sep 2019 at 19:00, Bob kb8tq <kb8tq at n1k.org> wrote:

> ...If you indeed want to do a quick and simple measurement that goes into
> 1 Hz ( or possibly less)
> the answer is to use a mixer based setup. A single mixer setup ( half of a
> DMTD) will do a much
> better job than a counter based approach. Cost wise it is not very
> expensive at all …
>
> Bob
>

I wonder if one of you clever people could design a circuit, and get kits
produced by TAPR ?

     Peter