[time-nuts] HP5065a cfield issue
Bob kb8tq
kb8tq at n1k.org
Wed Dec 2 19:36:24 UTC 2020
Hi
Just double checking….. Are we still after a change went past 1/3 of the pot range?
Can we get the pot back to the original location and measure the frequency offset
(even if only in a crude fashion)?
Best guess is still that this should be a ppb or more of shift. If it’s down in the
4x10^-11 range then indeed, there’s something off in the C Field setup.
Bob
> On Dec 2, 2020, at 2:03 PM, paul swed <paulswedb at gmail.com> wrote:
>
> Corby will check. Though in looking at the cfield circuits it does appear
> all to be correct. Its some other odd offset that has crept in.
> Thanks
>
> On Wed, Dec 2, 2020 at 1:56 PM <cdelect at juno.com> wrote:
>
>> Paul,
>>
>> One other thing to check.
>>
>> Put a DC coupled scope on the C-field pot wiper and rotate the pot back
>> and forth.
>>
>> Make sure there are no jumps or noise.
>>
>> Sometimes the pot gets noisy in a section.
>>
>> Rotating it back and forth across the bad sections will usually clean it
>> up.
>>
>> Cheers,
>>
>> Corby
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at lists.febo.com
>> To unsubscribe, go to
>> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
>> and follow the instructions there.
>>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list