[time-nuts] Pinout of 'Interface' connection of Lucent RFTGm-II-Rb and RFTGm-II-XO

[Tom Knox]

Hi Alex;
I have never seen one with a DB15, but perhaps I have not been paying attention.
So if my memory is correct these have one male DB9 power input connector and three female DB9 connectors.
What information are you looking for? I assume one of the female DB9 is a standard RS232.
I have the test cable and can check which pins to apply power. I also have the original wiring harness and can send a photo of that.
Feel free to contact me directly.
Cheers;

Tom Knox

actast at hotmail.com

"Peace is not the absence of violence, but the presence of Justice" Both MLK and Albert Einstein

________________________________
From: time-nuts <time-nuts-bounces at lists.febo.com> on behalf of Alexander Huemer <alexander.huemer at xx.vu>
Sent: Tuesday, July 14, 2020 9:57 AM
To: time-nuts mailinglist <time-nuts at lists.febo.com>
Subject: [time-nuts] Pinout of 'Interface' connection of Lucent RFTGm-II-Rb and RFTGm-II-XO

Hi

I own a pair of Lucent RFTGm-II-Rb and RFTGm-II-XO. I also have the pair
RFTG-u REF 0 and RFTG-u REF 1.
Interestingly enough the interconnection between these pairs is
different. The latter uses a D-sub 15 connector like VGA, though the
former uses D-sub 9 connectors.
I searched the web for the pinout of the former with no success.
Any pointers would be greatly appreciated.

-Alex OE2AHL


_______________________________________________
time-nuts mailing list -- time-nuts at lists.febo.com
To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.