[time-nuts] Re: WTB: Z3801A chassis or front panel
Eric Garner
garnere at gmail.com
Sat May 22 02:03:18 UTC 2021
I could just un-bend it, but the bend caused whatever paint/coating to
flake off too.
Eric
On Fri, May 21, 2021, 5:15 PM Hal Murray <hmurray at megapathdsl.net> wrote:
>
> > I recently acquired a Z3801a that UPS decided to mangle in shipping,
> bending
> > one of the "ears" on the front panel.
>
> Can you unbend it? I'm thinking of a big crescent wrench with something
> like
> a couple sheets of paper for anti-scratch padding.
>
> It might be good enough, or maybe just a lot less bad. The chances of
> getting
> significantly worse seem low.
>
> --
> These are my opinions. I hate spam.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com -- To unsubscribe send
> an email to time-nuts-leave at lists.febo.com
> To unsubscribe, go to and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list