[time-nuts] Re: Dimensioned Drawing LUCENT-SYMMETRICOM Z3810AS KS24361

[Lux, Jim]

On 2/5/22 7:00 PM, Martin Flynn wrote:
> Since my homemade version did not turn out as well as I had hoped, I 
> was planning to have my local fab shop laser cut a rack panel for our 
> "new" LUCENT-SYMMETRICOM Z3810AS (KS24361)
You might also check out frontpanelexpress.com - they do nice engraved 
and punched panels, remarkably inexpensively. (and basically flat plates 
of any kind - I've used them for breadboards and prototypes where you 
want to fasten down a bunch of minicircuits type parts).
>
> Before break out the ruler, anyone have a dimensioned drawing  of the 
> mounting and panel holes?
>
>
> Martin A Flynn / W2RWJ
> Computer Deconstruction Laboratory
> 2201 Marconi Road
> Wall Township, NJ 07719
> Tel: +01 732-456-5001
> Email: martin.flynn at compdecon.org
> Online: www.compdecon.org
> Facebook: https://www.facebook.com/compdecon/
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com -- To unsubscribe 
> send an email to time-nuts-leave at lists.febo.com
> To unsubscribe, go to and follow the instructions there.
>