[time-nuts] Re: GPSDO - GPS1300-10-1000 by RFX Ltd. UK

[Wilko Bulte]

hello Bryan,

Runnimg LH on a *Pi is feasible without any problems. I have built such a setup myself, it lives in my shack and is based on a Samsung UCCM GPSDO (telco surplus obtained in China). The Pi in question is an OrangePi Zero running Armbian Linux. It runs an Xdesktop on top of a VNCserver.  Obviously LH shows herself on that desktop ;-) This whole shebang allows running the GPSDO/OrangePi combo to run headless (i.e. without a display), one can use any VNCclient to check on LH via the network. Laptop, tablet, even a smartphone can be used to monitor the GPSDO. The OrangePi has both Wlan as well as wired Ethernet options.

Hope this makes sense, I did an article for Electron, the monthly of the Dutch VERON ham organisation. In Dutch, for obvious reasons. But can make it available if there is interest.

Wilko
PA1WBU

> On 2 Mar 2022, at 19:21, Bryan _ <bpl521 at outlook.com> wrote:
> 
> I have seen a project where ladyheather is run off a PI, suppose you could just configure LH to display what you need.
> 
> -=Bryan=-
> 
> ________________________________
> From: va2hdd at ebox.net <va2hdd at ebox.net>
> Sent: March 2, 2022 9:34 AM
> To: Discussion of precise time and frequency measurement <time-nuts at lists.febo.com>
> Subject: [time-nuts] Re: GPSDO - GPS1300-10-1000 by RFX Ltd. UK
> 
> Hello to all members.
> 
> I want to add to my lab a Pi based display that would show a GNSS SV map
> like the one attached to this message.
> 
> Any suggestions ?
> 
> Thank you !
> 
> Claude VA2 HDD
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com -- To unsubscribe send an email to time-nuts-leave at lists.febo.com
> To unsubscribe, go to and follow the instructions there.