[time-nuts] Re: Regarding RAPCO 2804 (Pendulum 2804)...
Björn
bg at lysator.liu.se
Sat Jun 3 10:21:07 UTC 2023
Sorry my units are Rapco 1804M. Donât know how similar that is to 2804.
Sent from my Phone
> On 3 Jun 2023, at 12:18, Björn <bg at lysator.liu.se> wrote:
>
> I would assume it is TSIP and not NMEA involved here.
>
> Ulf, I have one and probably another working unit. Would you have use for a working unit to compare with? Rapco branded. You based at the salty front side of Svedala?
>
> /Björn
>
>
> Sent from my Phone
>
>> On 3 Jun 2023, at 00:22, paul swed via time-nuts <time-nuts at lists.febo.com> wrote:
>>
>> Ulf
>> A consideration. When a ublox starts up the communications parameters
>> contain the Ublox messages not just NEMA.
>> Also the baud rate and parity and bit length may be wrong. You should be
>> able to sniff the old low sensitivity receiver to see what messages its
>> putting out and the other parameters and then try matching.
>> Good luck looks like a neat restoration.
>> Regards
>> Paul
>> WB8TSL
>>
>>> On Fri, Jun 2, 2023 at 4:17â¯PM Ulf Kylenfall via time-nuts <
>>> time-nuts at lists.febo.com> wrote:
>>>
>>>
>>> A big thank you for providing the manual !
>>> I began troubleshooting a few days ago. The OCXO is OK.The GPS module
>>> (Trimble 52830) seems to have low sensitivity asit can detect only a one or
>>> two satellites. I tried replacing it with a uBlox unitwith an identical
>>> footprint but the communication parametersdoes not match which stopped any
>>> further attempts so I put
>>> the clock aside but with the manual, I can now proceed.
>>> The indicated fault was "Erroneous lock +/- 5Hz".
>>>
>>> -5 Hz is when the DAC is at 0.2V output. It is a paralell loaded AD7846
>>>
>>> V e r y expenceive from distributors but several are availableon eBay at
>>> acceptable prices. I have to rule out the GPS modulebefore any further
>>> decisions.
>>> Once again: Thanks!
>>> Best Regards
>>> Ulf Kylenfall
>>>
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at lists.febo.com
>>> To unsubscribe send an email to time-nuts-leave at lists.febo.com
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at lists.febo.com
>> To unsubscribe send an email to time-nuts-leave at lists.febo.com
More information about the Time-nuts_lists.febo.com
mailing list