[time-nuts] Re: Two GPSDO 10 MHz phase drift

[Dana Whitlow]

Doug,

Have you tried the corresponding experiment of looking for time drift
between the
two 1 PPS signals' leading edges?  If so, what was the result?

Dana


On Fri, Mar 3, 2023 at 7:57 PM Doug Ronald via time-nuts <
time-nuts at lists.febo.com> wrote:

> I'm back for a new (to me) question:
> I have two TrueTime XL-DC receivers, one with an ovenized 10 MHz crystal
> oscillator and the other with a rubidium
> oscillator. Both are receiving from the same GPS antenna, and both
> receivers are tracking 5 or 6 satellites all the
> time. I repaired the rubidium clock itself where the oven was too hot to
> maintain internal lock, and has an external VCO
> line to pull the unit to the GPS 1 PPS. That line has a correction voltage
> that changes, then stabilizes to about 2.8
> VDC.
> With an oscilloscope, I monitor the phase of the 10 MHz from one unit to
> the other, and much to my surprise, the phase
> drifts, always in the same direction, but not linearly. It takes about 40
> minutes to complete a 360 degree cycle. I
> expected there would maybe be some tiny jitter in the phase, but not a
> continuous error.
> My fear is that one or both of the 10 MHz references is not being
> corrected to the GPS signal, but I thought I would ask
> here to see if this drift might be expected. Probably others have done
> this experiment, so I think I'll get a good
> answer.
> Thanks,
> Doug Ronald, W6DSR
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe send an email to time-nuts-leave at lists.febo.com
>