[volt-nuts] 3458A Questions - The Sequel
J. L. Trantham
jltran at att.net
Sat Oct 29 16:46:17 UTC 2011
Is there a way to tell if the Option 001 RAM is installed using only the
front panel controls?
What set up do you use to communicate via HPIB? I have several
possibilities that I can start playing with including PCI to HPIB boards, HP
and NI, with Win2K and XP, along with a USB to HPIB adapter. What program
do you use? I have downloaded the HP I/O Suites. I also have NI Labview.
I have not tried putting it all together yet. Any suggestions? Easiest
might be my XP laptop and the USB to HPIB adapter.
Joe
-----Original Message-----
From: volt-nuts-bounces at febo.com [mailto:volt-nuts-bounces at febo.com] On
Behalf Of Poul-Henning Kamp
Sent: Saturday, October 29, 2011 11:36 AM
To: Discussion of precise voltage measurement
Subject: Re: [volt-nuts] 3458A Questions - The Sequel
Opt 1 is just extra (volatile) RAM, a couple of standard RAM-chips will do
that for you, if you think you need it.
The six vs. one eprom is just that: one big instead of six smaller ones, the
functional change is the contents (typically rev8 vs rev9)
I don't know if rev9 can be put in 6 eproms, but I suspect it could, if
somebody sends me a dump (do it via HPIB) I'll be happy to find out.
More information about the volt-nuts
mailing list