[volt-nuts] Guide to programming the Hitachi 6303?

[Orin Eman]

Somewhere on my home PC, I already have a spreadsheet of the 6303
instruction set.  I don't recall if it was scanned or xls.

I'll check...

Orin.

On Mon, Apr 23, 2012 at 1:40 PM, Bob Paddock <bob.paddock at gmail.com> wrote:

> > I am massively hampered in this task as I don't have any experience of
> assembly programming 6800 or similar CPUs (or indeed any micro processors).
>  Are there any good resources online I can download, or books I can buy to
> that will get me on the road.
>
> Long version  where I answered that question on my blog:
>
> http://blog.softwaresafety.net/2011/03/how-do-i-get-started-in-this-field-with.html
>
> Short version, get this; "Understanding Small Microcontrollers" by
> James M. Sibigtroth:
>
>
> http://www.freescale.com/files/microcontrollers/doc/ref_manual/M68HC05TB.pdf
>
> 6805 is close enough to the 6800 that you'll get the concepts.
>
> I used the EPROM version of the 6303 long ago.  It was touchy to the
> reset pin timing.
> If it only has a pull-up and cap on the reset line, make sure that cap
> hasn't go bad.
>
> Do you truly have the ROM 6303 or do you have a EPROM 6303 (6703?
> Doesn't look right.)?
>
> Think I do still have a 6303 Op-Code Reference Cheat Sheet here that I
> could scan,  if that would help you out?  I know I got rid of the data
> books long ago.
>
>
>
>
> --
> http://blog.softwaresafety.net/
> http://www.designer-iii.com/
> http://www.wearablesmartsensors.com/
>
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
>