[volt-nuts] Sn10Pb90

[Volker Esper]

Hi Joe,

What are you looking for, Cadmium-Solder, or Sn10Pb90, which is 
Stannum/Plumbum-only?

And what do you what it for? In (very high) precision applications there 
are so many issues to consider that the solder doesn't appear to be at a 
high priority...

Volker


Am 12.08.2013 00:38, schrieb Joseph Gray:
> Reading through the archives, I saw that there was some discussion about a
> safer alternative to cadmium-based solder. The low tin, high lead alloy was
> recommended as a good low-thermal EMF substitute. However, I did not see
> any recommendations on where to buy some of this.
>
> I just did some searching and all I come up with is bar solder, mostly from
> China. Where can I buy a small quantity of rosin-core 10/90 solder? Mouser,
> which is my preferred vendor certainly didn't list any. I would think that
> even 1/2  pound would last me a lifetime.
>
> Joe Gray
> W5JG
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
>
>
>