[volt-nuts] Sn10Pb90
Rob Klein
rob.klein at smalldesign.nl
Tue Aug 13 15:38:17 EDT 2013
Op 13-8-2013 20:16, Joseph Gray schreef:
> I came across a couple of old Fluke differential voltmeters that need some
> work. I thought it would be best to use low thermal EMF solder on these.
>
I think it would be best *not* to.
As far as I know, Fluke never used any low thermal EMF solder on any of
its equipment, even
the very top-of-the-range stuff. I certainly never seen it mentioned in
any service manual
for e.g. the 720, 845, 750, 752.
Rob.
More information about the volt-nuts
mailing list