[volt-nuts] 34401A Why 10M ohm default i/p resistance?

[Andreas Jahn]

Hello,

perhaps its just to save the lifetime of the input range selection 
relays to at least the warranty time.
Just a guess.

With best regards

Andreas

Am 10.04.2014 19:58, schrieb Joel Setton:
> I think the 10 Meg default value became a de facto standard at the 
> time of VTVMs (vacuum-tube volt meters), as a convenient value which 
> reduced input circuit loading while remaining compatible with the grid 
> current of the input triode. Designers of early solid-state voltmeters 
> merely decided not to change a good thing.
> Just my $0.02 worth!
>
> Joel Setton
>
>
> On 10/04/2014 18:55, Steven J Banaska wrote:
>> As Tom said the 10M input impedance is used for the high voltage ranges
>> because it is a resistive divider (9.9M/100k) that can handle high 
>> voltages
>> without much drift. Caddock THV or HVD are fairly common in precision 
>> dmms.
>>
>> Typically you will find a high impedance (10G) path that can be used for
>> the ranges 10V and lower, but the 10M divider can be left connected and
>> will work for any voltage range by changing which side you measure. 
>> As you
>> mentioned there can be an accuracy sacrifice when you have a high output
>> impedance from your source. I'm not sure why 10M is the default other 
>> than
>> it may extend the life of the relay that switches the 10M divider in 
>> or out.
>>
>> Steve
>>
>>
>
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.