[volt-nuts] Fluke 732A battery module (and possible circuitreplacement)

[Dave M]

Todd Micallef wrote:
> Mark,
>
> If you need any scans or measurements, let me know. I have one that
> will be disassembled for the next 24hrs. I can get this for you
> tomorrow evening before I replace the batteries.
>
> Todd
>
> Sent from my iPad
>
>> On Aug 25, 2014, at 21:10, Mark Sims <holrum at hotmail.com> wrote:
>>
>> I have a 732A that is missing its battery module.  Does anybody have
>> or know of a source for a replacement?
>> Also,  would there be any interest in a replacement circuit assembly
>> for the battery module?  It would probably consist of a small board
>> that plugs into the 2x6 pin edge connector and another small board
>> with the ballast lamp/diode/resistor/thermistors and connections for
>> the battery/switch/external power jack.  The two boards would be
>> connected by a short ribbon cable and would allow one to add
>> batteries to a 732A that is missing the battery module.  It would
>> not be a complete battery module with the metal frame and
>> backplate... _______________________________________________

I'd like to have one, maybe two.  I have a couple of 732A units in the shop.

Dave M