[volt-nuts] Datron 1281 calibration enable key

[Todd Micallef]

I did the same for my Datron 4700 and Valhalla 2724a. I took a picture of that ebay listing to the locksmith for a laugh. The lock on the 4700 came out easily once the outer threaded cap of the lock was removed.

Todd

Sent from my iPad

> On Dec 7, 2014, at 11:10, David C. Partridge <david.partridge at perdrix.co.uk> wrote:
> 
> 1) Can you get into the case and remove the lock-switch? If yes, see 2)
> 
> 2) Take lock to lock-smith, get key made.  If they can't make a key to fit, they're not a lock-smith! 
> 
> Regards,
> David Partridge 
> -----Original Message-----
> From: volt-nuts [mailto:volt-nuts-bounces at febo.com] On Behalf Of Ludger.Lenzen at gmx.de
> Sent: 07 December 2014 14:20
> To: Discussion of precise voltage measurement
> Subject: [volt-nuts] Datron 1281 calibration enable key
> 
> I am searching for the calibration enable key for my Datron 1281.
> At EBAY one key for the Wavetek 4808 Calibrator is offered.
> 
> Does anybody know if this key fits also to the Datron 1281?
> 
> Thanks for Help.
> 
> PeLuLe / Germany
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
> 
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.