[volt-nuts] 732b transformer replacement

[Todd Micallef]

Willy asked me to post this ....

I just bought the battery pack on ebay for $700... that was me!

Yes, the transformer and regulator board are OK and I have
them powering the 732b right now!

Can you put this message on volt-nuts for me?

I can't figure out the process......

Thanks!
Willy





On Thu, Jun 5, 2014 at 2:15 AM, Poul-Henning Kamp <phk at phk.freebsd.dk>
wrote:

> In message <174201cf8064$ba75c900$2f615b00$@pcsupportsolutions.com>,
> "John Allen" writes:
>
> >Have you considered rewinding the transformer?
>
> I would start out checking very carefully if the wires have broken
> next to whatever they're soldered onto (lug/wire), one of the most
> common failure modes is a break right next to the solder-lug.
>
> --
> Poul-Henning Kamp       | UNIX since Zilog Zeus 3.20
> phk at FreeBSD.ORG         | TCP/IP since RFC 956
> FreeBSD committer       | BSD since 4.3-tahoe
> Never attribute to malice what can adequately be explained by incompetence.
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
>