[volt-nuts] Economical Standard Calibration

[Joe Hobart]

Dallas,

How accurately do you need the 731B set?

Where are you located?  I am in Flagstaff, Arizona

I have four 731s, and I know how to calibrate them.

I also have a 3458A and a Fluke 7001 that goes to Fluke for calibration soon.  I
do not know the turnaround time.

Joe


On 3/8/2014 3:13 PM, Dallas Smith wrote:
> Good point, not a meter a Fluke 731b transfer standard. no access to local labs.
> 
> On 3/8/2014 4:54 PM, Dr. David Kirkby wrote:
>> On 8 March 2014 21:44, Dallas Smith <dosmith at outlook.com> wrote:
>>> Hi nuts,
>>> This is my first post. The knowledge from contributors is amazing.
>>>
>>> Was wondering where one could economically get our_voltage standards
>>> calibrated_
>>> to some traceable standard since Joe Gellar suspended  operations for his
>>> SVR-T?
>>>
>>> voltagestandard.com doesn't sell a 10v references and two of his 5v
>>> Vref5-002 are costly.
>>>
>>> Dallas
>> It would be worth stating what meter you have. Clearly what is going
>> to be useful for a 3.5 digit meter, will not be for an 8.5 digit one.
>>
>> Dave
>> _______________________________________________
>