[volt-nuts] 732A rear panel battery connector

[Poul-Henning Kamp]

--------
In message <BLU170-W43993C7B1CB8ABA5625B8ACE970 at phx.gbl>, Mark Sims writes:

>Yes,  I have laid out a pair of boards that has the battery module
>circuits on them.  One board plugs into the mainframe (it has the
>thermistors on it) and the other has the rest of the circuitry.   I
>have not ordered them yet... I need to buy the festoon lamp connector
>and have been waiting until I have to order some more parts from
>Mouser.   What I didn't do is try and build the whole battery module
>with all the mechanical parts/frame/etc.  I may laser cut a back
>panel piece, though,  out of acrylic.

My plan was somewhat simpler:  Just a 24/24 isolated DC/DC converter
(for isolation obviously), no need for an extra set of batteries in
my case.


-- 
Poul-Henning Kamp       | UNIX since Zilog Zeus 3.20
phk at FreeBSD.ORG         | TCP/IP since RFC 956
FreeBSD committer       | BSD since 4.3-tahoe    
Never attribute to malice what can adequately be explained by incompetence.