[time-nuts] Buffering the 1pps output from a Z3801A
Dave Brown
tractorb at ihug.co.nz
Wed Mar 26 15:56:53 EDT 2008
Peter
All comments so far relate only to the Z3801A. The Trimble Thunderbolt
has a TTL level 1 pps 10 uSec pulse output on a BNC connector intended
to be loaded with 50 ohms. AFAIK there is no ECL level pps output
available from the Thunderbolt via its 9 pin serial port connector.
It's cetainly not mentioned in the Thunderbolt documentation if it is.
DaveB, NZ
----- Original Message -----
From: "Peter Vince" <pvince at theiet.org>
To: <time-nuts at febo.com>
Sent: Thursday, March 27, 2008 2:29 AM
Subject: [time-nuts] Buffering the 1pps output from a Z3801A
> Bruce, et al,
>
> The 1pps output of an HP Z3801A and Trimble Thunderbolt is
> only available (as far as I know) as a balanced ECL signal on the
> 25-pin connector, with dire warnings in the manuals about not
> earthing either side of the ECL signals. Would you be able to
> advise
> on a simple buffer circuit that would allow me to drive the usual
> unbalanced 50-ohm coax please?
>
> Thanks,
>
> Peter Vince (London, England)
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.519 / Virus Database: 269.22.0/1342 - Release Date:
> 25/03/2008 10:26
>
>
More information about the time-nuts
mailing list