[time-nuts] Navsync CW12 - More Info
Azelio Boriani
azelio.boriani at screen.it
Thu Jan 5 20:39:52 UTC 2012
OK, thank you.
On Thu, Jan 5, 2012 at 8:29 PM, Ed Palmer <ed_palmer at sasktel.net> wrote:
> Do you mean the reference oscillator for the 5372A? That was the internal
> 10811 OCXO. Over a 1000 sec. run, drift wouldn't have any affect on these
> numbers.
>
> Ed
>
>
> On 1/5/2012 12:54 PM, Azelio Boriani wrote:
>
>> Great, don't forget to specify what reference your measurements were made
>> from (or did I miss anything from your posts?).
>> We use the CW12 PPS for our GPSDOs.
>>
>> On Thu, Jan 5, 2012 at 6:57 PM, Ed Palmer<ed_palmer at sasktel.net> wrote:
>>
>> Okay, I've cooled off - a bit. The bottom line is that the 10 MHz output
>>> of the CW12 isn't appropriate for what I wanted to do. Ah, the joys of
>>> reading and understanding a spec sheet!
>>>
>>> But let's not throw out the baby with the bathwater. Although the 10 MHz
>>> output has it's issues for typical Time-Nut applications, the 1 PPS
>>> output
>>> is great. Here are some measurements that I've made over the past few
>>> years on a few GPS receivers and a couple of GPSDOs. I measure 1000
>>> periods of the 1 PPS and look at the results. Every run gives somewhat
>>> different results so I've shown some typical ranges. These measurements
>>> were made with an HP 5372A. YMMV.
>>>
>>> Device .............. Std Dev (ns).... Range (max-min)(ns) ... Device
>>> Type
>>>
>>> Navsync CW12 ........ 4 - 5 .......... 20 - 25 ............... GPS Rcvr
>>> Motorola UT+ ........ 40 - 55 ........ 95 - 110 .............. GPS Rcvr *
>>> see below
>>> Rockwell Jupiter .... 10 ............ 50 ................... GPS Rcvr
>>> **
>>> Motorola M12M ....... 10 - 15 ........ 40 - 60 ............... GPS Rcvr
>>>
>>> Trimble Thunderbolt . 0.4 - 0.5 ...... 2 - 4 ................. GPSDO
>>> HP Z3801A ........... 0.3 ............ 2 ..................... GPSDO
>>> ***
>>>
>>>
>>> * Most of my UT+ 'range' results were in this group, but there were a
>>> few at 20 - 30.
>>> ** Only one result.
>>> *** Only one result. I need to do more testing on the Z3801A
>>>
>>>
>>> As you can see, the Navsync CW12 is by far the best of the GPS Receivers,
>>> but nowhere near as good as the GPSDOs. However, imagine using the CW12
>>> to
>>> discipline a good OCXO to build your own GPSDO. Or using it to
>>> discipline
>>> a PRS10 Rubidium or X72 Rubidium oscillator. You can't do it with the 10
>>> MHz output, but the 1 PPS output is another story.
>>>
>>> Ed
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to
>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>>>
>>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list