[time-nuts] High Stability OCXO for Pendulum CNT-90
Stan
swperk at earthlink.net
Tue Oct 27 01:01:27 EDT 2015
Hello all,
I have a Pendulum CNT-90 with the standard oscillator option. I notice that
there is an open area on the main PCB where a higher stability reference
would be installed.
1) Is it possible to install an aftermarket high stability reference
oscillator into this stock CNT-90 and be able to use it?
2) If so, is it just a matter of soldering an appropriate OCXO module
into the designated area on the PCB?
3) Will the CNT-90 automagically recognize it, or are there jumpers or
other things that have to be done to enable it?
4) Any recommendations for a good, high stability reference to use?
Thanks,
Stan
More information about the time-nuts
mailing list