[time-nuts] New TAPR "TADD" kit in the works -- are you interested?
NE8S
ne8s at earthlink.net
Fri Dec 23 18:03:22 UTC 2005
John, N8UR,
I would be interested in one or two of TADD-3.
Happy Holidays!
Gar, NE8S
----- Original Message -----
From: "John Ackermann N8UR" <jra at febo.com>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>; <time-freq at lists.tapr.org>; <tacgps at lists.tapr.org>
Sent: Thursday, December 22, 2005 4:27 PM
Subject: [time-nuts] New TAPR "TADD" kit in the works -- are you interested?
> The TAPR TADD-3 kit is just about ready to go into production, and I
> have no idea how many people might be interested in one (you can tell
> TAPR is full of engineers rather than marketers...). This email is to
> get an idea of interest so we can judge how many kits to make up in the
> initial run.
>
> The TADD-3 is a 1 pulse per second distribution system. It has two
> inputs and eight outputs. Six of the outputs are low-Z TTL level
> signals routed to BNC connectors, while two are RS-232 levels to drive a
> serial port. Each output can be individually strapped to invert the
> input signal, or leave it alone. (Note: while the TADD-3 is designed
> primarily for PPS signals, there's no bandwidth limiting and it should
> work with any pulse train up to at least several MHz.)
>
> Each input can be selected to drive either a 74AC14 Schmitt trigger (TTL
> level) or an LT1016 high-speed comparator (with trigger point adjustable
> from 0 to 5 volts). The LT1016 has less than 10ns delay, and initial
> tests show jitter that's not much worse than driving the 74AC14
> directly; it's a good chip. The two signal inputs can be bridged so one
> signal can drive all eight outputs.
>
> The form factor is the same as the TADD-1 RF distribution amplifier: a
> 4x6 inch board with the 6 output BNCs on one long side, and the two
> input BNCs on the other. Provisions are made to stack multiple boards.
>
> We don't have a price set yet (it will depend in part on the volume we
> do) but a very rough estimate is $60-$90 for the kit.
>
> We are also working on an enclosure that will work with this, and all
> the other, TADD kits, but we don't have availability or pricing
> information available yet.
>
> If you'd be interested in buying a TADD-3 kit, please contact me off the
> list. I'm not looking for binding orders, just an idea of the interest
> level so we choose an appropriate size for the first run.
>
> Thanks and happy holidays,
>
> John
>
> _______________________________________________
> time-nuts mailing list
> time-nuts at febo.com
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
More information about the Time-nuts_lists.febo.com
mailing list