[time-nuts] Fan for old HP synthesizer (was RE: time-nutsDigest, Vol 21, Issue 20)
Daun Yeagley
daun at yeagley.net
Tue Apr 18 19:49:37 UTC 2006
I'd say that the biggest concern after physical size and Voltage requirements is
that it has an adequate CFM rating. That's THE most important.
Daun
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On Behalf
Of Poul-Henning Kamp
Sent: Tuesday, April 18, 2006 3:43 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Fan for old HP synthesizer (was RE: time-nutsDigest,
Vol 21, Issue 20)
In message <001d01c6631e$8f49b960$8301000a at fakie>, "Christopher Hoover" writes:
>As someone else mentioned, the form factor is often quasi-standard.
>Poring over the Digi-Key catalog may be your best bet.
>
> Mtg Hole Ctr Sp - English : 3.25 in
> Thkns - English : 1.5 in
This is what's called a 92mm x 92mm x 38mm fan these days.
There are many 92x92x25 mm fans available, you may be able to substitute one of
these if 92x92x38 is impossible to find.
--
Poul-Henning Kamp | UNIX since Zilog Zeus 3.20
phk at FreeBSD.ORG | TCP/IP since RFC 956
FreeBSD committer | BSD since 4.3-tahoe
Never attribute to malice what can adequately be explained by incompetence.
_______________________________________________
time-nuts mailing list
time-nuts at febo.com
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
More information about the Time-nuts_lists.febo.com
mailing list